Home  > Technical Support > Molding Technology > Molding Technology for LAPEROS(R) LCP

Properties - Post Shrinkage

Contents Introduction Pre-drying Use of Regrinds Selection of Molding Machine
 Mold Designing Molding Properties Molding Conditions Safety Precautions

FlowabilityMolding ShrinkagePost Shrinkage

LAPEROS(R) LCP Grade Composition This page's PDF(619KB)

6. Molding Properties

6.3  After-Shrinkage

Fig. 6-11 shows the relationship between annealing time and after-shrinkage for A130 at 150°C and 200°C. It can be seen that after 2 hours of annealing, the after-shrinkage rate reaches saturation.

Fig. 6-11 After-Shrinkage of A130

 


FlowabilityMolding ShrinkagePost Shrinkage

Contents Introduction Pre-drying Use of Regrinds Selection of Molding Machine
 Mold Designing Molding Properties Molding Conditions Safety Precautions