Home  > Technical Support > Molding Technology > Molding Technology for TOPAS(R) COC

Mold design

Contents Introduction Cautions in molding Molding machines Molding conditions
Molding characteristics Product design Mold design Countermeasures for defects  
Sprues, runners Gates Draft angle Undercut Gas vents Temperature control Mold material
List of TOPAS® COC grades This page's PDF(2.41MB)
← Previous Next →

7. Mold design

7.4 Undercut

With TOPAS® COC, undercutting is basically impossible. When the surface is embossed, for instance, whether the embosses do not become an undercut should be considered.

 

← Previous Next →
Sprues, runners Gates Draft angle Undercut Gas vents Temperature control Mold material
Contents Introduction Cautions in molding Molding machines Molding conditions
Molding characteristics Product design Mold design Countermeasures for defects