Website Maintenance on August 2
Our website will be unavailable from 9:30 until 13:30 on August 2 (Japan time) due to system maintenance. We apologize for any inconvenience and thank you for your understanding.

 Home  > Technical Support > Molding Technology > Molding Technology for DURACON® POM

Molding Characteristics / Flow Characteristics

Contents Introduction Safety Molding Machines Molding Conditions Recycling
Molding Characteristics Product Design Mold Design Countermeasures for Defects

Flow Characteristics  Mold Shrinkage  After-shrinkage / Absorptional Change  Thermal Stability

List of DURACON® POM grades This page's PDF(0.97MB)

6. Molding Characteristics

6.1 Flow Characteristics


Fig. 6-1 Bar flow length of M90-44
(thin wall section)

Fig. 6-2 Bar flow length of M270-44
(thin wall section)

Fig. 6-3 Bar flow length for 2mm

Fig. 6-4 Bar flow length for 0.5mm

 

    Molding conditions: Cylinder temp. 190°C, Mold temp. 80°C and Injection speed 67mm/s

 


Flow Characteristics  Mold Shrinkage  After-shrinkage / Absorptional Change  Thermal Stability

Contents Introduction Safety Molding Machines Molding Conditions Recycling
Molding Characteristics Product Design Mold Design Countermeasures for Defects