Polyplastics Co,.Ltd.

 Home  > Technical Support > Product Design

Calculation Tools for Design

  • Materia Selection
  • Beam Calculation
  • Gear Calculation(Fatigue)
  • Gear Calculation(Wear)
  • Snap fit Calculation
  • Press fit Calculation
  • Screw Calculation
  • Heat Analysis Tool
Name Description
Materia Selection Would you like to select one of our products suitable for you?
Beam Calculation Design calculation can be carried out for cantilevers and and simply supported beams both of which are commonly known in the area of material dynamics.
Notice: Dependence of apparent modulus of elasticity on strain
Gear Calculation(Fatigue) It is possible to calculate fatigue and wear endurance for gears made of our plastics materials.
Gear Calculation(Wear) It is possible to calculate fatigue and wear endurance for gears made of our plastics materials.
Snap fit Calculation Snap fitting by using cantilevers, which is a typical design, is discussed here. Thrusting force can be estimated.
Notice: Points for consideration on the design of Snap-Fit
Press fit Calculation Calculation of press fitting can be performed. Strain and pullout force/drag torque can be calculated that occur when a shaft is press fitted into a resin hub.
Screw Calculation The tightening torque or the number of screw threads for Duracon screw can be calculated.
Heat Analysis Tool This tool is able to calculate the maximum temperature of a heating element after 500 seconds.
Heating element in contact with a plastic plate is assumed as an analysis model.

Fake Products on Market

Recommended browser is Internet Explorer ver 8.0 or higher.

OUTPUT PAGE

WEB@TSC
Technical Documents PDF Plastic Pavilion Careers Group introduction movie