Polyplastics Co,.Ltd.

HOME > Technical support > Product Design > Calculator tools for design

Calclation of the strain in snap fit

On this page, strain generated in snap-fit coupling structures using our materials can be calculated.

Please input parameters

  Material DURACON ® M90
1 Length (L) mm
2 Deformation (Y) mm
3 Thickness (t) mm
Result
Strain --- %
1Length (L)
mm
2Deformation (Y)
mm
3Thickness (t)
mm

For customers who desire a further specific analysis, we will carry out a review for the following two patterns.

Contact Us

For customers who desire a specific examination of the above, please proceed from here.

The data presented in this home page are prepared based on the experiences and laboratory data accumulated by our company, and they are not necessarily applicable to components used under different conditions. Therefore, we are not in a position to guarantee that these contents can be applied as they are to each of the individual conditions of the customers, and the customers are to make decisions by themselves about the utilization of such data. Also, we are not in a position to guarantee that the implementation, application, processing, or use of the information provided in the home page by the customers is exempted from any infringement of the intellectual property rights of any third parties.

Fake Products on Market

Recommended browser is Internet Explorer ver 8.0 or higher.

OUTPUT PAGE

WEB@TSC
Technical Documents PDF Plastic Pavilion Careers Group introduction movie