Molding technology for Duracon

HOME > Technical support > Molding technology > Molding technology for Duracon >

Standard molding Conditions

Safety and Hygiene Precaution

Injection Molding Machines

Molding Conditions

Recycling

Molding Characteristics

Products Design

Mold Design

Preventive Measures for Molding Defects

Standard molding Conditions

Predrying

Molding Conditions

Molding Cycle

Measures for Preventing Mold Deposit

3Selection of Molding Conditions
3.1Standard Molding Conditions of Duracon

Predrying: 80-90 peke 3-4 hours
Material melt temperature: 190-210
Mold temperature: 60-80
Injection pressure: 49-98Mpa
Injection speed: 5-50mm/s(0.3-3m/min)
Screw rotation: 100-150 rpm

Molding cycle (Injection purasu Holding pressure) : Gate sealing time purasu
(Cooling) : Plasticizing time or ejection capable time

The data shown in this home page are based on our accumulated experience and laboratory data, and not always directly applicable to your products used under different conditions. Therefore, we can not guarantee that the contents of this home page are directly applicable as they are to the specific condition in our customers, and we appreciate your final decision on the use of these data.