 |
| <Important> |
| • |
Consult the appropriate bulletins
for the grade to be used, technical data or Material Safety Data Sheet
(MSDS) for proper use of FORTRON®.
|
| <Hazards> |
| • |
If FORTRON®
pellets lie scattered on the passage or floor, you may slip and stumble.
Clean the passage or floor immediately. |
| • |
If FORTRON®
is caught on fire, use water, foam fire extinguishing system, chemical
powder fire extinguishing system or carbon dioxide fire extinguishing
system.
|
| <Notes for molding FORTRON®> |
•
• |
Predry pellets at 140°C
for approximately 3 hours.
To prevent decomposition of the material, observe the material temperature
and the in-cylinder retention time listed below. |
|
| 1) |
 |
2) |
Limit in-cylinder retention
time:
| Cylinder Temperature |
Maximum Residence Time |
| 300°C |
60min. |
| 320°C |
30min. |
(The above conditions give a standard,
and may vary under different conditions.) |
|
|
Optimum material temperatures: 300 - 320°C [Do not heat
above 360°C.] |
|
| • |
If the material is decomposed
or suspected to be decomposed, reduce the cylinder temperature, and
purge (discharge) the material from the cylinder. During purging,
wear safety goggles and keep your hands and face away from the nozzle
section. |
| • |
Do not mix any colorants,
additives or resins of other brands with FORTRON®,
except those we recommend. |
| • |
Keep the workplace ventilated
locally or entirely during operation.
|
| <Others> |
| • |
The information contained
herein is all the data available at present for using this material.
However, we have not confirmed the accuracy and integrity of the information
in all its aspects.
|
| • |
If the pellets leaks on the
floor, plumbing, or elsewhere, it could damage the waterway and ocean
environments. Be sure to repair all leaks immediately. |
FORTRON(PPS)